Automatic Light Switching Version - APRILIA RS 125 - 1996 Manual

After repairing a tyre, have the wheels balanced.
Use only tyres in the size suggested by aprilia
(see "TECHNICAL DATA" - page 82).
Do not install tyres with air tube on rims for tube-
less tyres and vice versa.
Make sure that the tyres always have their valve
sealing caps, to prevent them from suddenly go-
ing flat.
Change, reparation, maintenance and balancing
operations are very important and should be car-
ried out by qualified technicians with appropriate
tools.
For this reason, it is advisable to have the above
mentioned operations carried out by an aprilia
Official Dealer or by a qualified tyre repairer.
If the tyres are new, they may still be covered
with a slippery film: drive carefully for the first kil-
ometres.
Do not oil the tyres with unsuitable fluids.
INFLATION PRESSURE
FRONT ......................................... 180 kPa (1,8 bar)
REAR ............................................. 200 kPa (2 bar)
FOR DRIVE WITH PASSENGER
FRONT ......................................... 180 kPa (1,8 bar)
REAR .......................................... 230 kPa (2,3 bar)
MINIMUM TREAD DEPTH LIMIT
FRONT ............................................................ 2 mm
REAR ............................................................. 2 mm
40
AUTOMATIC
LIGHT SWITCHING VERSION
The vehicles provided with the Automatic Switch-on
Device can be immediately recognized, since the
lights come automatically on as soon as the engine is
started.
For this reason the light switch is replaced by a dim-
mer switch.
The lights can be switched off only by stopping the
engine.
Before starting the vehicle, make sure that the
dimmer switch is in position "
_
b
" (front low beam).