APRILIA MX 50 - 07-2002 Manual page 148

MX50-UK02.fm Page 38 Tuesday, July 30, 2002 2:50 PM
Fig. 36
Fig. 37
38
CHANGING THE HEADLIGHT BULBS
(Fig. 36)
To change the low and high beam bulbs, proceed
as follows:
Remove the rubber cup (1);
◆
Remove the connector;
◆
◆ Act on the "V"-spring and extract the socket with
the bulb;
Replace the damaged bulb;
◆
To reassembly, carry out the same operations re-
◆
versing the order.
To change the parking light bulb, proceed as fol-
lows:
Remove the rubber socket (2) and extract the bulb;
◆
If it is damaged, replace the bulb.
◆
CHANGING THE REAR LIGHT BULBS
(Fig. 37)
Proceed as follows:
Unscrew the two screws (1);
◆
◆ Remove the glass (2);
◆ Press the bulb slightly and rotate it anticlockwise;
Remove the bulb from its seat.
◆
The introduction of a new bulb can be
carried out in one sense only, since the
two guide pins are misaligned.
◆ Install a new bulb correctly, then repeat the above
operations in the reverse order for the reassem-
bly.