Removing The Headlight Fairing; Adjusting Idling Speed - APRILIA ATLANTIC 200 - 2003 Manual

2
1
REMOVING THE HEADLIGHT
FAIRING
R e a d p a g e 6 0 ( M A I N T E N A N C E )
carefully.
◆
Place the vehicle on the center stand.
◆
Remove the rearview mirrors, see page
page 73 (REMOVING THE REARVIEW
MIRRORS).
◆
Remove the front cover, page 74
(REMOVING THE FRONT COVER).
◆
Loosen and remove the two headlight
fairing fixing screws (1).
◆
Remove the headlight fairing (2).
1

ADJUSTING IDLING SPEED

R e a d p a g e 6 0 ( M A I N T E N A N C E )
carefully.
Adjust idling speed when it seems uneven.
To do this:
◆
Travel a few miles
functioning temperature has been
reached, see coolant oil temperature
indicator " ", page 31 (INSTRUMENTS
AND INDICATORS CHART), then stop
the engine.
◆
Place the vehicle on the center stand.
◆
Remove the right inspection cover, see
page page 73 (REMOVING THE RIGHT
AND LEFT INSPECTION COVERS).
2
◆
Connect an electrical rev counter to the
spark plug wire.
◆
Start the engine.
T h e e n g i n e i d l i n g s p e e d m u s t b e
approximately:
– 1,750 ± 100 rpm/min.
200
In this case the rear wheel is not set in
until normal
motion by the engine.
If necessary:
◆
Open the helmet compartment under the
saddle.
◆
Unscrew the screw (3) and remove the
protective cover (4)
◆
Regulate the adjusting screw (5), located
on the carburetor.
SCREW (clockwise) to increase the
number of revolutions.
UNSCREW (counterclockwise) to reduce
the number of revolutions.
5
use and maintenance Atlantic 200
USA
75