ZyXEL Communications VANTAGE RADIUS 50 Quick Start Manual page 16

To avoid premature errors, make sure you first configure your access point
before configuring authentication settings and wireless clients.
6.1 ZyAIR G-3000 RADIUS Settings Example
The following example describes how to configure your AP's RADIUS server settings for use with
a RADIUS server.
To set up your ZyAIR's RADIUS server settings, click the WIRELESS link under ADVANCED
and then the RADIUS tab. The screen appears as shown.
Step 1. Make sure your RADIUS servers are activated.
Step 2. Type the IP address of your Vantage RADIUS in the Server IP Address field.
Step 3. Type the port numbers of the external authentication and accounting servers. The default
port numbers are 1812 and 1813 respectively.
Step 4.
Type a password (up to 31 alphanumeric characters) as the key to be shared between the
external authentication server and the wireless AP. The key must be the same on the
external authentication server and your wireless AP. The key is not sent over the
network.
Vantage RADIUS 50 Quick Start Guide
14