Configuring 802.1X - ZyXEL Communications PRESTIGE 335 User Manual

P-335 Series User's Guide
Table 34 Wireless: 802.1x and Static WEP
LABEL
IP Address Enter the IP address of the external accounting server in dotted decimal
Port Number Enter the port number of the external accounting server. The default port number
Shared Secret Enter a password (up to 31 alphanumeric characters) as the key to be shared
Preamble
802.11 Mode
G+ Enhanced
Apply
Reset

8.14 Configuring 802.1x

In order to configure and enable 802.1x; click the WIRELESS link under ADVANCED to
display the Wireless screen. Select 802.1x + No WEP from the Security list.
128
DESCRIPTION
notation.
is 1813.
You need not change this value unless your network administrator instructs you
to do so with additional information.
between the external accounting server and the Prestige.
The key must be the same on the external accounting server and your Prestige.
The key is not sent over the network.
Select a preamble type from the drop-down list menu. Choices are Long, Short
or Dynamic. The default setting is Long. See the section on preamble for more
information.
Select 802.11b Only to allow only IEEE 802.11b compliant WLAN devices to
associate with the Prestige.
Select 802.11g Only to allow only IEEE 802.11g compliant WLAN devices to
associate with the Prestige.
Select Mixed to allow either IEEE802.11b or IEEE802.11g compliant WLAN
devices to associate with the Prestige. The transmission rate of your Prestige
might be reduced.
Select G+ Enhanced checkbox to allow any ZyXEL WLAN devices that support
this feature to associate with the Prestige. This permits the Prestige to transmit
at a higher speed than the 802.11g Only mode.
Click Apply to save your changes back to the Prestige.
Click Reset to reload the previous configuration for this screen.
Chapter 8 Wireless Security