ZyXEL Communications P-2612HW Quick Start Manual page 6

3. PHONE: Use a telephone cable (and any telephone adaptor provided
with your P-2612HW-F1) to connect a telephone to the PHONE 1 or
PHONE 2 port.
4. Use the power adaptor provided with your P-2612HW-F1 to connect
an appropriate power source to this socket.
5. Push the power button to the on position.
Look at the LEDs (lights) on the top panel of the P-2612HW-F1.
• The POWER light blinks during start-up and is green once the P-
2612HW-F1 is ready.
• Each ETHERNET light turns on if the corresponding ETHERNET
port is properly connected. The lights blink when the P-2612HW-F1
is sending or receiving data through the corresponding ETHERNET
port.
• The ADSL light stays on if a physical DSL connection exists and
blinks when transmitting data.
The WAN light stays on if this port is properly connected and blinks
when transmitting data.
The INTERNET light is green when Internet access is available.
• The PHONE lights stay on when your SIP account is registered and
they blink if the receiver is off the hook.
6