ZyXEL Communications MES-2110 User Manual page 58

Chapter 6 Configuration
Table 11 Configuration > Rmon Status (continued)
LABEL
InBadOctets
InUndersize
InFragments
InJabber
InOversize
TX
The following fields show detailed information about frames transmitted.
OutUnicasts
OutBroadcasts
Late
Excessive
Multiple
Single
Deferred
RX+TX
64 Octets
65to127 Octets
128to255 Octets
256to511 Octets
512to1023 Octets
1024toMax Octets
58
DESCRIPTION
This field shows the number of bad octet frames received.
This field shows the number of frames received that were too short
(shorter than 64 octets).
This field shows the number of frames received that were too short
(shorter than 64 octets) and were received with with Cyclical
Redundancy Check (CRC) errors.
This field shows the number of frames received with a length that
exceeds the maximum octet size and were received with CRC errors.
This field shows the number of frames received with a length that
was out of range.
This field shows the number of good unicast frames transmitted.
This field shows the number of good broadcast frames transmitted.
This is the number of times a late collision is detected, that is, after
512 bits of the frames have already been transmitted.
This is a count of frames for which transmission failed due to
excessive collisions. Excessive collision is defined as the number of
maximum collisions before the retransmission count is reset.
This is a count of successfully transmitted frames for which
transmission was inhibited by more than one collision.
This is a count of successfully transmitted frames for which
transmission is inhibited by exactly one collision.
This is a count of frames for which transmission delayed due to busy
traffic. The deferred frames are waiting to be transmitted from the
Switch buffer. This counter only works for the half-duplex mode.
This field shows the number of frames (including bad frames)
received that were 64 octets in length.
This field shows the number of frames (including bad frames)
received that were between 65 and 127 octets in length.
This field shows the number of frames (including bad frames)
received that were between 128 and 255 octets in length.
This field shows the number of frames (including bad frames)
received that were between 256 and 511 octets in length.
This field shows the number of frames (including bad frames)
received that were between 512 and 1023 octets in length.
This field shows the number of frames (including bad frames)
received that were between 1024 and the maximum octets in length.
MES-2110 User's Guide