Lacp Link Status - ZyXEL Communications MES-2110 User Manual

Table 43 Configuration > Trunk Config > LACP Configuration (continued)
LABEL
System
Priority
Undo
Apply

15.6 LACP Link Status

Click Configuration > Trunk Config > LACP Link Status in the navigation
panel to open the following screen.
Figure 52 Configuration > Trunk Config > LACP Link Status
The following table describes the labels in this screen.
Table 44 Configuration > Trunk Config > LACP Link Status
LABEL
Actor
MAC
Priority
Port ID
Key
Priority
Partner
MAC
Priority
Port ID
Key
Priority
MES-2110 User's Guide
DESCRIPTION
LACP system priority is a number between 1 and 65535. The switch with
the lowest system priority (and lowest port number if system priority is the
same) becomes the LACP "server". The LACP "server" controls the
operation of LACP setup. Enter a number to set the priority of an active
port using Link Aggregation Control Protocol (LACP). The smaller the
number, the higher the priority level.
Click this to restore your last saved settings.
Click this to save your changes.
DESCRIPTION
This is the local Switch.
This is the local Switch's MAC address.
This is the local Switch's priority level.
This shows the port number belonging to the trunk group.
This is the local Switch's key value.
This is the port priority level.
This is the peer Switch.
This is the peer Switch's MAC address.
This is the peer Switch's priority level.
This shows the port number belonging to the trunk group.
This is the peer Switch's key value.
This is the port priority level.
Chapter 15 Link Aggregation
105