Advertisement
SYSTEM CONNECTION
Before connecting acoustic equipment, pay attention to the picture below.
Each connection must be safe and firm. Disconnect power cable until you have
finished all the connections.
DVD Player
PC
FM antenna
5
BASIC OPERATION
PREPARATION
1) Before the unit is turned on, please check if all the connections are right and safe.
Then connect the main power.
2) Press the
POWER ON/OFF
button on the back panel to turn on the main power.
3) Press the
STANDBY
button on the remote control (or front panel) to exit the standby
mode.
STATE INDICTION OF DISPLAY SCREEN
1. In radio status, show the received frequency and mono/stereo.
2. In Audio-input, IPOD status, show the signal input and main volume status.
STANDBY MODE
Press the
STANDBY
button on the remote control (or on front panel) to switch
ON/OFF the Standby mode.
Note: Make sure that the unit is connected to the power source.
SLEEP BUTTON
In play status, press the
SLEEP
button on the remote control continuously, you can get
the different sleep time for this unit: 10 min, 20 min, 30 min, 60 min, 90 min, 120 min.
For example, if you press the
SLEEP
sleep mode in 10 minutes.
MUTE BUTTON
If you press the
MUTE
button while playing, sound signal will not be heard, but the
picture will remain. Press the
MUTE
button again or the
the previous volume level.
FAST FORWARD AND FAST REWIND
In play status, press the
or
Note: These buttons are unavailable in Audio Input mode.
PREVIOUS AND NEXT
In play status, press the
button to go to the previous audio file; press the
button to go to the next audio file.
Note: These buttons are unavailable in Audio Input mode.
VOLUME SETTING
Press the
VOL.+/-
buttons to turn the volume up or down.
button to select ``10 min``, the unit will enter
VOL+/-
buttons to resume
button to fast rewind or fast forward.
6
Advertisement
