Chapter 4 Troubleshooting - Eizo FLEXSCAN SX3031W User Manual

Chapter 4 Troubleshooting

If a problem still remains after applying the suggested remedies, contact your local dealer.
• No-picture problems → See No.1 - No.2.
• Imaging problems → See No.3 - No.9.
• Other problems → See No.10 - No.12.
• USB problems → See No.13.
Problems
1. No picture
• Power indicator does not light.
• Power indicator is lighting blue.
• Power indicator is lighting orange.
2. The message below appears.
• This message appears when no signal is input.
[Single Display]
[Dual Display]
In dual display mode, the error message appears only
when both of SIGNAL1 and SIGNAL2 have errors.
• The message below shows that the input signal is
out of the specified frequency range. (Such signal
frequency is displayed in red.)
Example:
[Single Display]
[Dual Display]
In dual display mode, the error message appears only
when both of SIGNAL1 and SIGNAL2 have errors.
3. Characters are blurred.
4. The screen is too bright or too dark.
18
Chapter 4 Troubleshooting
Possible cause and remedy
• Check whether the power cord is connected correctly.
• Press
• Switch the input signal with
• Operate the mouse or keyboard.
• Turn on the PC.
• Either SIGNAL1 or SIGNAL2 may have an error in dual
display mode. Check that in <Information> (see
14).
This message appears when the signal is not input
correctly even when the monitor functions properly.
• The message shown left may appear, because some
PCs do not output the signal soon after power-on.
• Check whether the PC is turned on.
• Check whether the signal cable is connected properly.
• Switch the input signal with
only)
• Select an appropriate display mode using the graphics
board's utility software. Refer to the manual of the
graphics board for details.
• Adjust using <Smoothing>.
• Adjust <Brightness>. (The LCD monitor backlight has a
fixed life span. When the screen becomes dark or begins
to flicker, contact your local dealer.)
.
page
. (Single display mode