Beeper Setting; To Set The Beeper [Beep]; Selecting Input Signal; To Select Input Signal [Input Signal] - Eizo FLEXSCAN SX3031W User Manual

2-11 Beeper Setting

●

To set the beeper [Beep]

Set the beeper on/off for operation tone of the switches, connection error, etc.
Sound type
Short beep
Long beep
Consecutive beeps
Beep-beep once every 15
seconds
(1) Choose <Others> from the Adjustment menu, and press
(2) Choose <Beep> from the <Others> menu, and press
The <Beep> menu appears.
(3) Select "On" or "Off" with
The beep setting is completed.

2-12 Selecting Input Signal

●

To select input signal [Input Signal]

In single display mode, this function allows you to select the signal displayed
on the monitor.
Priority setting
Auto When either PC is turned off or enters the power-
saving mode, the monitor automatically displays
signals of another PC.
Manual The monitor does not detect the PC's signals
automatically. Select an active input signal with
(1) Choose <Others> from the Adjustment menu, and press
(2) Choose <Input Signal> from the <Others> menu, and press
The <Input Signal> menu appears.
(3) Choose <Auto/Manual> with
Conditions for beeping
• When is pressed.
• When an item is selected with
• When a maximum or minimum value is set with
the control switches.
• When is pressed.
• When registration is performed with
• When the monitor is not connected correctly.
• When the PC is not turned on.
• When no signal is received.
• When a frequency out of the specified range is
received.
• 15 minutes before the power off time set by "Off
Timer" (advance notice time)
or , and press
Function
or , and press
.
.
.
.
.
.
.
.
.
Chapter 2 Settings and Adjustments
NOTE
• When the input signal setting is
"Auto" in single display mode, if
no input signal is received on both
SIGNAL1 and SIGNAL2 port, the
signal port selecting function is
performed at every two seconds.
15