Printer Language - SATO CG408 Operator's Manual

MODEL NAME
RIBBON
(BE SURE TO USE RIBBON MANUFACTURED OR CERTIFIED BY SATO)
Wind Direction
Winding Method
Roll Diameter
Core Diameter
Length
Width
PROCESSING
CPU
Flash ROM
SDRAM

PRINTER LANGUAGE

Standard
INTERFACES
Standard Configurations
SENSING
Gap (Transmissive)
I-Mark (Reflective)
Cover Open
Ribbon End
Dispenser
Linerless label sensor
LABEL ISSUING MODES
CG4 Series Operator Manual
CG408 DT CG412 DT
—
32 Bit RISC-CPU 133 MHz
SATO Barcode Printer Language (SBPL)
Select one of the following. (The factory will provide the unit with the selected
1) USB 2.0 (Type B) with RS-232C (D-SUB 9-pin type) or
2) USB 2.0 (Type B) with LAN (10BASE-T/100BASE-TX Automatic Switching) or
3) USB 2.0 (Type B) with IEEE1284
*The RS-232C connector can be used to connect the printer to a computer, an
optional keypad, Smart keyboard or Barcode scanner.
Not available
Fixed (Only available if installed)
Fixed (Only available if installed)
Standard: Continuous mode, Tear-off mode, Sensor off mode
Optional mode: Dispenser mode, Cutter mode, Linerless (Nonsepa) mode
Section 6: General Specifications
CG408 TT
Maximum outer diameter: 1.4" (38 mm)
Inner core diameter: 0.5" (12.7 mm)
Max. 328 ft. (100 m). Do not exceed the
maximum outer diameter.
4.33" +/- 0.01" (110 mm +/- 0.5 mm)
4 Megabytes
8 Megabytes
interface.)
Sensitivity Adjustable
Sensitivity Adjustable
Fixed
Fixed (Only available for Thermal
Transfer model)
CG412 TT
Face Out
Paper core
Use only
Page 6-3