Table of Contents
Advertisement
Chapter 4 Introduction to Effects and Parameters
Key
Select the key of the song that you wish to play.
Attack
Adjust the strength of the attack. By adding an attack to each
note of the phrase you can produce a sensation as though the
notes were being picked.
Hold
If you turn hold "On" after you pick a note, the effect sound
will continue even after there is no input signal.
Effect Level
Adjust the volume of the phrase.
Direct Level
Adjust the volume of the direct sound.
Creating Original Phrases (User Phrase)
In addition to the 30 different prepared phrases, you can also
create up to ten of your own original phrases (User phrases).
1. Press [FX-2], then press PARAMETER [
that "FX Select" is displayed.
2. Rotate the PATCH/VALUE dial to select "AR."
3. Press [FX-2] a number of times to select "Phrase," then
rotate the PATCH/VALUE dial to select "User 1–10."
4. Press PARAMETER [
have the User Phrase settings screen displayed.
fig.04-050d
5. Press PARAMETER [
then rotate the PATCH/VALUE dial to set the User
phrase.
User:
specify the user phrase number.
IN:
Sets the note name of the input sound. You can also play
individual notes on the guitar and let the GS-10 judge
the note name.
STEP:
Sets the step of the phrase.
You can also play on the guitar and put the step forward.
50
] [
] so
] a number of times until you
] [
] to move the cursor,
OUT:
Specify the note name of the output sound.
The triangle next to the note name indicates the octave.
One downward-pointing triangle indicates a note one
octave below the note displayed; two triangles indicates
a two-octave drop.
One upward-pointing triangle indicates a note one
octave above the note displayed; two triangles indicates
a two-octave rise.
SYN (Guitar Synth)
This detects the pitch of an electric guitar and outputs a
synthesizer sound.
* When you use a guitar synthesizer, observe the following
points.
• It does not work properly when a chord is played. Be
sure to mute all the other strings and play in a single
note.
• When you are to play the next string while a certain
sound is still playing, perfectly mute the previous sound
then play the next one with a clear attack.
• If the unit cannot detect the attack, it may not sound
correctly.
Parameter
Sens
Wave
Chromatic
Octave Shift
PWM Rate
PWM Depth
Cutoff Freq
Resonance
FLT.Sens
FLT.Decay
FLT.Depth
Attack
Release
Velocity
Hold
Synth Level
Direct Level
Sens (Sensitivity)
This adjusts the input sensitivity. The response of the internal
sound source is better with a higher sensitivity value, but the
malfunctions will be increased on the other hand. So, try to
set it as high as possible without causing malfunction.
Value
0–100
Square, Saw, Brass, Bow
Off, On
Wave= Square, Saw
0, -1, -2
Wave= Square, Saw
0–100
Wave= Square
0–100
Wave= Square
0–100
0–100
0–100
0–100
-100 –100
Decay, 0–100
0–100
0–100
Off, On
Wave= Square, Saw
0–100
0–100
Advertisement
Table of Contents
