Boss BR-1600CD Basic Operation Gude page 69

9
Use the TIME/VALUE dial to set the
write speed.
Write Speed:
x2 (352 kbps) Writes twice as fast.
x4 (704 kbps) Writes four times as fast.
x8 (1408 kbps) Writes eight times as fast.
• If the CD-R disc already contains data, the message "Not Blank Disc!" will appear and writing will not be possible.
Always use an empty disc.
• If the CD-RW disc already contains data, the message "Erase Disc?" will be displayed. If you then press [ENTER/
YES], the BR-1600CD will begin erasing data from the CD-RW disc.
• The audio track chosen as a source must be stereo.
• If the audio track contains no recorded audio data or if no CD track markers have been set up in the recorded
performance, "NO TRACK" will be displayed in the list and writing will not be possible.
• Audio CD specifications require that songs be at least four seconds in length. CD track markers that set up any song of
less than four seconds in length will be ignored when the CD is being created.
• If the total length of the songs to be written exceeds the CD-R/RW disc's maximum recording time, the message "CD Full!"
will appear and writing will not be possible. In such a case, change the positioning of the CD track markers ( Owner's
Manual; p. 49), use track cut (Owner's Manual; p. 62), or use track erase (Owner's Manual; p. 63) to reduce the total time to
less than the disc's maximum recording time.
• The range of available write speeds can sometimes be limited by the type of disc being used. In such a case, the BR-
1600CD will allow you to select only the supported speeds on step 9.
• To cancel writing while this operation is in process, press [EXIT/NO]. When the message "Cancel?" appears, press
[ENTER/YES] to confirm cancellation. (A certain amount of time may pass between pressing of [EXIT/NO] and
display of the confirmation message.) Please note, however, that no guarantee can be made regarding the state of the
data written before cancellation. Care must also be taken with CD-R discs in particular as this media cannot be written
to a second time.
• You will not be able to eject a disc during the writing process, even if you press EJECT button.
Writing your finished song to a CD (Audio CD Write)
10
11
Press [ENTER/YES].
The message "Write Sure?" will appear.
Press [ENTER/YES] once again.
The message "Now Writing..." will appear and
writing of the audio CD will begin. When the message
"Complete!" appears, it indicates that writing has
been completed.
69