Creating a patch (Patch mode)
Transmitting patch/rhythm settings
from the MIDI OUT connector
(XFER to MIDI)
You can transmit the settings of any patch from the MIDI OUT
connector. This function can be used to save patch settings on an
external sequencer.
Select the patch or the rhythm set you want to output.
5. Use VALUE [-]/[+] to select "CURRENT PATCH" or "USER
PATCHES."
If you selected "CURRENT PATCH," proceed to step 8.
range of user patch numbers that you want to transmit.
fig.r03-24_40
range of user patch numbers that you want to transmit.
fig.r03-25_40
The selected patch settings will be transmitted from the MIDI
After the data has been transmitted, the display will indicate
"COMPLETED." This ends the procedure.
Restoring the factory settings
(FACTORY RESET)
You can also perform the FACTORY RESET operation from Patch
Utility.
For more about FACTORY RESET, refer to "Reset to default
factory settings (Factory Reset)" (p. 20).
62
]/[
] to select "4:XFER to MIDI."
] to specify the first number of the
] to specify the last number of the