Roland RS-70 Owner's Manual page 141

fig.Win-03.e
9.
In the dialog box that appears, input the
following into the "Open" field, and click
[OK].
E:\Win2000\RS-70\SETUPINF.EXE
* The drive name "E:" may be different for
your system. Specify the drive name of your
CD-ROM drive.
fig.Win-04.e
10.
The SetupInf dialog box will appear.
You are now ready to install the driver.
11.
Connect the RS-70.
1. With the RS-70's power switch turned
off, connect it to the AC adaptor.
2. Plug the AC adaptor into an AC power
outlet.
3. Use the USB cable to connect the RS-70
to your computer.
12.
Set the RS-70's power switch to the ON
position.
Near the task bar, your computer will indicate "Found New Hardware." Please
wait.
fig.Win-05.e
13.
The Found New Hardware wizard will
appear.
Make sure that the screen indicates
"Roland RS-70," select "Install from a
list or specific location (Advanced),"
and click [Next].
fig.Win-06.e
14.
The screen will indicate "Please choose
your search and installation options."
Select "Don't search. I will choose the
driver to install," and click [Next].
Performing with a computer
In this manual, the location
of folders and files is given
in terms of the file path,
using \ as the delimiter.
For example,
RS-70\SETUPINF.EXE
indicates the
SETUPINF.EXE file found
in the RS-70 folder.
This unit is equipped with
protection circuit. A brief
interval (a few seconds)
after power up is required
before the unit will operate
normally.
141