Patch E Ect Settings In Performance Mode - Roland Juno-G Micro Manual

7. You can adjust the Chorus and Reverb processor sends with the
Audio Input Cho Send and Audio Input Rev Send parameters,
respectively.
8. Next, press EFFECTS and adjust the e ects processors as you like.
You can save these settings as a patch or as a performance. When
you save your song (press WRITE and select Save Song), these
settings are saved within it as well.
Patch effect settings in performance mode
Part of the Juno-G patches actively use the e ects processors to produce
the nal sound. However, when you call up such patches in performance mode,
these e ects settings are not loaded by default. In order for a patch to load it's
e ects settings, you need to do the following:
1. Select a performance part and assign a patch to it.
2. Press EFFECTS.
3. Set the OUTPUT parameter on the screen (marked "2" on the image
below) to "MFX".
4. Set the MFX SEL parameter (marked "3") to one of the free MFX
processors (1, 2 or 3).
5. Then, set the MFX settings source (marked "1") to the number of the
performance part you are working with (see step 1).
6. If needed, set the Chorus and Reverb processor settings sources to
the same part number as well.
1
2
3
9