Table of Contents
Advertisement
11
The system and the other setup
Remote Control Mode Setup
• Default setting: 1
This sets this receiver's remote control mode to prevent
erroneous operation when multiple units of the receiver
1
are being used.
1
Select 'Remote Control Mode Setup' from the
Other Setup menu.
4d.Other Setup
A/V RECEIVER
1. KURO LINK Setup
2. Multi Ch In Setup
3. ZONE Audio Setup
4. Power ON Level Setup
5. Volume Limit Setup
6. Remote Control Mode Setup
7. Flicker Reduction Setup
Exit
2
Select the Remote Control Mode setting you want.
3
Select "OK" to change the remote control mode.
4
Follow the instructions on the screen to change the
remote control's setting.
See Operating multiple receivers on page 73.
5
When you're finished, press RETURN.
You will return to the Other Setup menu.
Flicker Reduction Setup
• Default setting: 4
The GUI screen's resolution can be increased. If you feel
the GUI screen is hard to see, try changing this setting.
Note this setting only affects the GUI screen; it has no
influence on the video output.
1
Select 'Flicker Reduction Setup' from the Other
Setup menu.
4d.Other Setup
A/V RECEIVER
1. KURO LINK Setup
2. Multi Ch In Setup
3. ZONE Audio Setup
4. Power ON Level Setup
5. Volume Limit Setup
6. Remote Control Mode Setup
7. Flicker Reduction Setup
Exit
2
Select the Flicker Reduction setting you want.
3
When you're finished, press RETURN.
You will return to the Other Setup menu.
Note
1 If you change this receiver's setting, also change the setting on the remote control.
96
En
4d6.Remote Control Mode Setup
A/V RECEIVER
Remote Control Mode :
1
OK
Return
Exit
4d7.Flicker Reduction Setup
A/V RECEIVER
Flicker Reduction :
4
Return
Exit
Cancel
Finish
Advertisement
Table of Contents
