4.
Roll up three putties around the cables and fit them into the holes to prevent
water from getting inside Network Camera. Use last putty to fix the spot.
Notes
•
Confirm Network Camera is functioning before puttying the cables. Putties
and Self Bonding tape cannot be used twice.
•
Check the length and the type of the Ethernet cable before fixing with putty.
5.
Cover the putties by rolling.
•
Self Bonding tape is used to mount Network Camera on a wall or ceiling,
so leave half the Self Bonding tape.
5 –10 mm
(0.2–0.4 inches)
6.
Connect the Ethernet cable to the Ethernet port of hub, router and PC.
[For assistance, please call: 1-800-272-7033]
Three putties
Seal cables with
Self Bonding tape.
Operating Instructions
Last putty
Do not cover
the ventilation hole.
95