Recording Setup Screen - Panasonic AG-HPX370 Operating Instructions Manual

Item
USER MAIN Sets the function assigned to the USER MAIN button.
REC REVIEW, SPOTLIGHT, BACKLIGHT, ATW,
ATWLOCK, GAIN: 24 dB, Y GET, DRS, TEXT MEMO,
SLOT SEL, SHOT MARK, MAG A. LVL, PRE REC,
PC MODE, WFM, FBC
For details, refer to [Assigning Functions to USER
buttons] (page 61).
USER1 Sets a function assigned to the USER1 button. The
functions that can be assigned to this button are the
same as for the USER MAIN button.
BACKLIGHT (factory default setting)
For details, refer to [Assigning Functions to USER
buttons] (page 61).
USER2 Sets a function assigned to the USER2 button. The
functions that can be assigned to this button are the
same as for the USER MAIN button.
TEXT MEMO (factory default setting)
For details, refer to [Assigning Functions to USER
buttons] (page 61).
RET SW Sets the function assigned to the RET button on the
lens.
REC REVIEW, TEXT MEMO, SHOT MARK, INHIBIT
• When INHIBIT is selected, the RET button function is
WFM Selects the waveform displayed in the LCD monitor
when the user button to which WFM has been
assigned is pressed.
WAVE: Displays a waveform.
VECTOR: Vectorscope display
WAVE/VECT: Each press of the button, switches
the settings in the following order: OFF
(waveform)
AUTO KNEE SW Selects the function of the OUTPUT/AUTO KNEE.
ON: Setting AUTO KNEE to ON turns on the AUTO
KNEE function.
OFF: The AUTO KNEE function is not available even
when AUTO KNEE is set to ON.
DRS: Setting AUTO KNEE to ON turns on the DRS
(Dynamic Range Stretcher) function. (For details, refer
to page 12.)

RECORDING SETUP screen

Item
REC FUNCTION Sets special recording modes.
NORMAL: The special recording modes are not used.
INTERVAL: Sets interval recording.
ONE SHOT: Sets one-shot recording.
LOOP: Sets loop recording.
For details, refer to [Special Recording Modes]
(page 42).
• This function is always set to NORMAL when the
18
Setting
disabled.
 
VECTOR OFF.
Setting
power is turned on.
• When a remote control unit (AJ-
RC10G) or extension control unit (AG-
EC4G) is connected, the SPOTLIGHT
and BACKLIGHT functions are not
available.

WAVE
• When set to 1080/30P or 1080/24P
mode, selecting DRS produces the
same effect as selecting ON.
• Not available in the following
conditions.
- When REC SIGNAL is set to 1394
- When REC FORMAT is set to native
recording.
- When SYSTEM MODE is set to 1080-
59.94i or 480-59.94i; and CAMERA
MODE is set to 24P or 24PA.
- When compiling to a clip in one-clip
recording mode.
____ indicates the factory setting
Notes
Notes