Recording Setup Screen - Panasonic AG-HVX202AEN Operating Instructions Manual

Setup menu list (continued)

RECORDING SETUP screen

Item
REC FORMAT (P2)
P2
REC FORMAT
(TAPE)
TAPE
576i REC MODE
P2
REC FUNCTION
P2
ONE-SHOT TIME
P2
INTERVAL TIME
P2
PREREC MODE
P2
REC SPEED
TAPE
AUDIO REC
TAPE
MIC ALC
P2 TAPE
MIC GAIN 1
P2 TAPE
MIC GAIN 2
P2 TAPE
25M REC CH SEL
P2
106
Display
mode
(Camera) Selects the recording format for P2 card.
1080i/50i, 1080i/25P, 720P/50P, 720P/25P, 720P/25PN, 576i/50i, 576i/25P
(Camera) Selects the recording format for cassette tape.
576i/50i, 576i/25P
(Camera) Select the recording mode for a 576i recording format.
DVCPRO50, DVCPRO, DV
(Camera) Selects the special recording mode. (Pages 47 - 49)
NORMAL, INTERVAL, ONE SHOT, LOOP
(Camera) Selects the one-shot recording time. (Page 49)
1F, 2F, 4F, 8F, 16F, 1s
(Camera) Selects the interval time for interval recording. (Page 48)
2F, 4F, 8F, 16F, 1s, 2s, 5s, 10s, 30s, 1m, 5m, 10m
(Camera) Sets PRE RECORDING to ON or OFF. (Page 47)
ON OFF
(Camera)
Selects the recording time mode.
(VCR) SP: SP (standard) mode
(DUB) LP: LP (long play) mode
(Camera) Selects the audio recording mode for conversion to PCM audio.
(VCR) 32K(12bit): 12bit/32kHz
48K(16bit): 16bit/48kHz
(Camera) Sets mic level auto control to ON or OFF. (Page 53)
ON OFF
Set to ON to reduce distortion at high input levels.
This setting does not change the audio signal recording level. Use the AUDIO
control knob to adjust the audio signal recording level.
(Camera) Sets the input level of the external microphone connected to the INPUT 1
terminal. (Page 52)
-50dB -60dB
(Camera) Sets the input level of the external microphone connected to the INPUT 2
terminal. (Page 52)
-50dB -60dB
(Camera) Selects the recording audio channel for DVCPRO25 and DV formats. (Page 52)
2CH, 4CH
<Notes>
•• Even when 4CH is selected as this item’' s setting, the signals will be
input to two channels (always CH1 and CH2) when there are two 1394
input channels.
•• Similarly, even when 4CH is selected, the 1394 output signals will be
delivered to two channels (always CH1 and CH2).
Description of settings
indicates the factory setting.