Possible cause
The settings are returned to the factory default settings when the
camera is turned off.
ALL RESET is set to
ON.
No picture is displayed on the TV when connected to the camera.
The video output
signal is incorrect.
The camera is not in
the playback mode.
The TV video signal
setting is incorrect.
Corrective action
Select the SETUP tab in the mode menu and set
ALL RESET to OFF.
Set the video output signal according to the region
where used.
Set the mode dial to any position except q.
Set the TV to the video input mode.
Troubleshooting
Ref. Page
P.128
P.151
P.120
P.120
167
10