Olympus CAMEDIA C-740 Ultra Zoom Reference Manual page 167

Troubleshooting
Possible cause
The viewfinder or monitor is hard to see.
The diopter is not
adjusted properly.
The brightness of the
viewfinder or monitor
is not adjusted
properly.
The monitor is
exposed to direct
sunlight.
Vertical lines appear
on the image in the
viewfinder or
monitor.
Pictures you have taken do not appear on the monitor.
The power is off.
The camera is in the
shooting mode.
There are no pictures
on the card.
There is a problem
with the card.
The camera is
connected to a TV.
The date recorded with the image data is wrong.
The date/time is not
set.
The batteries are
10
exhausted.
The camera has
been left with the
batteries removed.
Single-frame erase or all-frame erase cannot be performed.
The picture you want
to erase is protected.
166
Corrective action
Adjust the diopter so that the AF target mark is
clearly visible.
Select s in the mode menu and adjust the
brightness.
Block the sunlight with your hand or use the
viewfinder.
Bright light, such as direct sunlight, may cause
vertical lines to appear on the image. This is not a
malfunction.
Set the mode dial to q before pressing the
power switch to turn the camera on.
Press f twice quickly, or set the mode dial to
q.
"NO PICTURE" appears on the monitor. Record
pictures.
Refer to "Error codes".
The monitor does not function when the video
cable is connected to the camera.
Set the date/time. The clock adjustment is not
factory-preset.
When the batteries run out, the date/time setting
may be canceled. Replace the batteries with new
ones and set the date/time again.
If the camera is left for several hours with the
batteries removed, the date/time setting is
canceled. Set the date/time again.
Display the protected image (with 9) and press
0 to cancel the protection.
Ref. Page
P.30
P.142
—
—
P.108
P.108, 109
—
P.163
P.120
P.28
P.18, 28
P.18, 28
P.125