Installing The Firewall License - Nortel 5109 User's Manual And Command Reference

Installing the Firewall license

Once the Setup utility has been used for basic system configuration, the Setup menu is no
longer displayed upon subsequent log-ins. Instead, the CLI Main Menu is displayed:
[Main Menu]
>> Main#
Use the following CLI commands to install your Check Point licenses on the Firewall host, and
configure information about the network.
N
OTE
join installation. After the trial period ends, a license error appears when you try to push
policies to the Switched Firewall. Additionally, each time you log into the SmartCenter server,
it displays a notification of how many days are left before the trial period ends.
If local licensing is used, enter Check Point licensing information for the Firewall.
N
OTE
from the Check Point SmartCenter Server in a later step.
The license information will be part of your Check Point package. The license(s) you received
from Check Point should be specifically configured for your firewall Host IP address.
213455-L, October 2005
Nortel Switched Firewall 2.3.3 User's Guide and Command Reference
info - Information Menu
cfg - Configuration Menu
boot - Boot Menu
validate - Validate configuration
security - Display security status
maint - Maintenance Menu
diff - Show pending config changes
apply - Apply pending config changes
revert - Revert pending config changes [global command]
paste - Restore saved config with key [global command]
help - Show command help
exit - Exit
– The Switched Firewall ships with a 15-day trial license that auto-installs for a new or
– If central licensing is used, skip this step. With central licensing, the license is pushed
[global command, always available]
[global command]
[global command]
[global command]
Initial setup 43