Table of Contents
Advertisement
/cfg/fw
Firewall Configuration Menu
[Firewall Configuration Menu]
The Firewall Configuration Menu is used to enable the Firewall or reset the Check Point
Secure Internal Communications (SIC).
Table 78 Firewall Configuration Menu (/cfg/fw)
Command Syntax and Usage
ena
Enable the Check Point Firewall-1 NG processing on all healthy Firewalls.
dis
Disable the Check Point Firewall-1 NG processing on the firewall and mark the Firewall
as down. The Check Point SmartCenter Server cannot be used to manage Firewall poli-
cies in the disabled state. However, the current firewall policies are maintained.
N
lost. Be sure to use the command when you are accessing the Firewall CLI at the local
console.
sic
This command is used to reset the Check Point Secure Internal Communication (SIC)
state for a specific Firewall. You will be prompted to enter the IP address of the target
Firewall in dotted decimal notation.
sync
The Sync Configuration Menu is used to enable/disable session state synchronization
between clustered Firewalls in a redundant configuration.
See
213455-L, October 2005
Nortel Switched Firewall 2.3.3 User's Guide and Command Reference
ena
- Enable Firewall
dis
- Disable Firewall
sic
- Reset Check Point SIC.
sync
- Sync Configuration Menu
portal
- Portal Configuration Menu
client
- SMART Clients
smart
- Smart Update Configuration Menu
secureid
- Download secure-id configuration file from an
FTP server
–
When /cfg/fw/dis is entered, remote access to the Firewall CLI or the BBI is
OTE
page 361
for menu items.
Command reference
359
Advertisement
Table of Contents
