Table of Contents
Advertisement
If the Firewall has not been previously configured for network access, you must provide
information about network settings such as IP address, network mask, and gateway IP address.
After the new boot image has been installed, the Firewall will reboot and you can log in again
when the login prompt appears.
4.
Restore the configuration from the tftp server using the /cfg/gtcfg command.
5.
Reboot. This is required to apply the restored configuration file.
6.
Re-establish SIC and push policies from the Check Point SMART Client.
213455-L, October 2005
Nortel Switched Firewall 2.3.3 User's Guide and Command Reference
Upgrading and reinstalling the software
243
Advertisement
Table of Contents
