Niles ZR-6 Installation Manual page 43

IR PROGRAMMING
PROGRAMMING SOURCE DEVICE IR COMMAND CODES
3. Press the Next button to proceed to the next command
code. Follow steps 1 and 2 above for each command
code that is to be edited or erased.
4. Press the Program button to advance to the next
source device to be edited.
ERASING INDIVIDUAL DEVICE SEQUENCES
1. While in programming mode, press the Program button
until the desired source sequence page is shown on the
display.
P R O G T U N E R
B U I L D S E Q U E N C E
2. To erase the sequence for the displayed device, press
the Erase button.
3. The display will show [ERASE SEQUENCE -/NO +/
YES]
E R A S E S E Q U E N C E
- / N O + / Y E S
4. Press the + button to erase the sequence. The
sequence that was previously stored in this location is
now erased.
5. Press the – button to exit erase mode and return to the
previous step without erasing the sequence.
ERASING ALL IR COMMAND AND SEQUENCE PRO-
GRAMMING FOR ONLY ONE SOURCE
1. While in the Programming mode, press Program
until the desired source device name is displayed
with [TEACH POWER ON] or if a library page [ENTER
NILES]
P R O G S O U R C E 3
T E A C H P O W E R O N
2. Press-and-hold the Program and Erase buttons.
NILES AUDIO CORPORATION – 1-800-BUY-HIFI – 305-238-4373
0 1
3. The display will show [ERASE ALL IR+SEQ "SRC 3"
-/NO +/YES]
E R A S E A L L I R + S E Q
L I B 1 - / N O + / Y E S
4. Press + to erase the commands and sequences for the
selected device. The commands and sequences that
were previously stored in this location are now erased.
5. Press – to exit erase mode and return to the previous
step without erasing the commands and sequences.
6. Continue erasing or press-and-hold the Program
button to exit IR Programming mode.
ERASING IR AND SEQUENCE PROGRAMMING FOR ALL
SOURCES
1. While in the programming mode, press-and-hold the
Program, Next and Erase buttons until the display
shows [ERASE ALL IR+SEQ PRGRM -/NO -/YES].
E R A S E A L L I R + S E Q
P R G M - / N O + / Y E S
2. Press the + button to erase all IR commands and
sequences. All commands and sequences that were
previously stored in the ZR-6 are now erased.
3. Press – button to exit erase mode and return to the
previous step without erasing any commands and
sequences.
4. Press-and-hold the Program button to exit IR
Programming mode.
(CONTINUED ON NEXT PAGE)
41