Niles ZR-6 Installation Manual page 36

SYSTEM CONFIGURATION
CONFIGURING THE ZR-6 MULTIZONE RECEIVER
Press the Band button to toggle the "Y" on or off in the
highlighted zone. Only zones with a "Y" will respond to whole
house turn on.
1 2 3 4 5 6
Y Y Y
NOTE: IN THIS EXAMPLE ZONES 1, 2 AND 3 ARE CONFIGURED FOR
PARTY MODE.
After "6" on the Master, it will toggle to "1" on the fi rst
connected Slave. After "6" on the last connected Slave it will
toggle back to "1" on the Master.
Repeat these steps until all of the desired zones have been set for
the desired Party mode operation.
To continue to the next system confi guration step, PAGE MODE
VOLUME, press the Set button once.
To save the settings and exit the confi guration mode,
simultaneously hold down the Band and Set buttons. After the
ZR-6 saves the information, [RELEASE BUTTONS TO CONTINUE]
appears on the display. The ZR-6 will return to the normal operating
mode.
PAGE MODE VOLUME
The paging volume level for the selected zones is adjustable.
Since the paging volume level will be the same for all zones,
we suggest setting a comfortable level in the room that will
be used most frequently, or in the smallest room. While in the
confi guration mode (see above), press the Set button until [PAGE
MODE VOLUME = XX] shows in the display.
P A G E M O D E
V O L U M E = 6 0
Press the + button to increase the paging volume. Press the - key
to decrease the paging volume. The factory default setting is 60.
The volume range is from 0 to 99.
P A G E M O D E
V O L U M E = 3 4
34
P A R T Y
M A S T E R
To continue to the next system confi guration step, Zone 4 Pre-Out,
press the Set button once.
To save the settings and exit the confi guration mode,
simultaneously hold down the Band and Set buttons. After the
ZR-6 saves the information, [RELEASE BUTTONS TO CONTINUE]
appears on the display. The ZR-6 will return to the normal operating
mode.
ZONE 4 PRE-OUT
The ZR-6 MultiZone Receiver is equipped with Zone 4 pre-amplifi er
outputs that enable the use of a separate outboard power amplifi er.
While in the confi guration mode (see above), press the Set
button until the display shows [ZONE 4 PRE-OUT VARIABLE].
The default setting is for the preamplifi er outputs to be variable (the
output level is controlled by the ZR-6 volume control).
Z O N E 4 P R E O U T
V A R I A B L E
To change these outputs to a fi xed volume level, press the Band
button. The display will show [PRE-OUT 4 FIXED]. The Zone 4
Output is now set to +6dB relative to the selected source device
input level.
Z O N E 4 P R E O U T
F I X E D
To continue to the next system confi guration step, Zone 5 Pre-Out,
press the Set button once.
To save the settings and exit the confi guration mode,
simultaneously hold down the Band and Set buttons. After the
ZR-6 saves the information. [RELEASE BUTTONS TO CONTINUE]
appears on the display. The ZR-6 will return to the normal operating
mode.
NILES AUDIO CORPORATION – 1-800-BUY-HIFI – 305-238-4373