Changing Lamp Mode - NEC NP300 User Manual

2. Press the SELECT  button.
The area of the magnified image will be moved
3. Press the MAGNIFY (-) button.
Each time the MAGNIFY (-) button is pressed, the image is reduced.
NOTE:
• The image will be enlarged or reduced at the center of the screen.
• Displaying the menu will cancel the current magnification.

 Changing Lamp Mode

This feature enables you to select two brightness modes of the lamp:
Normal and Eco modes. The lamp life can be extended by using the Eco mode.
Lamp Mode
NORMAL
ECO
To change to the [ECO] mode, do the following:
1. Press the LAMP MODE button on the remote control to display [LAMP MODE] screen.
2. Use the SELECT  or  button to select [ECO] mode.
3. Press the ENTER button.
To change from [ECO] to [NORMAL], Go back to Step 2 and select [NORMAL]. Repeat Step 3.
NOTE:
• The LAMP MODE can be changed by using the menu.
Select [SETUP] → [GENERAL] → [LAMP MODE].
• The lamp life remaining and lamp hours used can be checked in [USAGE TIME]. Select [INFO.] →[USAGE TIME].
• The projector is always in [NORMAL] for one minute after the lamp is turned on and while the POWER indicator is blinking green.
The lamp condition will not be affected even when [LAMP MODE] is changed.
• After a lapse of 3 minutes from when the projector displays a blue, black or logo screen, [LAMP MODE] will automatically switch
to [ECO]. The projector will return to the [NORMAL] once a signal is accepted.
• If the projector is overheated in [NORMAL] mode, there may be a case where the [LAMP MODE] automatically changes to [ECO]
mode to protect the projector. When the projector is in [ECO] mode, the picture brightness decreases. When the projector comes
back to normal temperature, the [LAMP MODE] returns to [NORMAL] mode.
Thermometer symbol [
high.
Description
This is the default setting (100%
Brightness).
Select this mode to increase the
lamp life (approx. 70% Brightness
o n N P 6 0 0 / N P 5 0 0 W / N P 6 0 0 S /
NP500WS and approx. 80% Bright-
ness on NP500/NP400/NP300).
] indicates the lamp mode is automatically set to [ECO] mode because the internal temperature is too
Status of LAMP indicator
Off
Steady Green light
4
4. Convenient Features
OFF ON
POWER
MAGNIFY PIC-MUTE PAGE
UP
DOWN
MENU
ENTER EXIT
LAMP
STATUS
LAMP
STATUS