Selecting A Source; Selecting The Computer Or Video Source - NEC NP300 User Manual

 Selecting a Source

Selecting the computer or video source

NOTE: Turn on the computer or video source equipment connected to the projector.
Selectng from Source Lst
Press and quickly release the SOURCE button on the projector cabinet to
display the Source list. Each time the SOURCE button is pressed, the input
source will change as follows: "COMPUTER1", "COMPUTER2(DIGITAL/
ANALOG)", "VIDEO", "S-VIDEO", To display the selected source, allow
1 second to elapse.
Detectng the Sgnal Automatcally
Press and hold the SOURCE button for a minimum of 2 seconds, the
projector will search for the next available input source. Each time you
press and hold the SOURCE button for a minimum of 2 seconds, the
input source will change as follows:
COMPUTER1 → COMPUTER2(DIGITAL) → COMPUTER2(ANALOG)
→ VIDEO → S-VIDEO → COMPUTER1 → ...
TIP: If no input signal is present, the input will be skipped.
Usng the Remote Control
Press any one of the COMPUTER 1/2, VIDEO, and S-VIDEO buttons.
TIP: The COMPUTER 2 button on the remote control toggles the Computer 2 source
between [COMPUTER2(DIGITAL)] and [COMPUTER2(ANALOG)].
Selectng Default Source
You can set a source as the default source so that it will be displayed
each time the projector is turned on.
1. Press the MENU button.
The menu will be displayed.
2. Press the SELECT  button twice to select [SETUP] and press the
SELECT  button or the ENTER button to select [GENERAL].
3. Press the SELECT  button three times to select [OPTIONS(2)].
4. Press the SELECT  button six times to select [DEFAULT SOURCE
SELECT] and press the ENTER button.
The [DEFAULT SOURCE SELECT] screen will be displayed.
(→ page 72)
5. Select a source as the default source, and press the ENTER but-
ton.
6. Press the EXIT button a few times to close the menu.
7. Restart the projector.
The source you selected in step 5 will be projected.
TIP: When the projector is in Standby mode, applying a computer signal from a
computer connected to the COMPUTER 1 IN input will power on the projector
and simultaneously project the computer's image.
([AUTO POWER ON(COMP1)] → page 72)
3. Projecting an Image (Basic Operation)
L-CLICK
VIDEO
S-VIDEO
VOLUME
9
MENU
SELECT
LAMP
STATUS
SOURCE AUTO ADJ.
R-CLICK
MOUSE
COMPUTER AUTO ADJ.
1
LAMP MODE
2
ASPECT HELP
PICTURE FREEZE