Mackie SR40.8 Owner's Manual page 83

Addendum/Errata
For the SR40•8/SR56•8 Owner's Manual:
Okay kidz! It's time to sharpen up your number 2 pencil and make a few changes in your manual.
1. On page 19:
In the section Intercom, the Pin outputs should read:
Pin 1 = ground/0V, Pin 2 = 28–30VDC, Pin 3 = audio + DC signalling.
2. On page 44:
Globally clearing all Mute Groups from
In the section
read:
"See 'Using the MIDI Ports' on page 50 or 'Using the DATA Port' on page 52."
3. On page 45:
Previewing Mute
In the section
Preview mode and save it to memory. The last paragraph in step 3 should read:
"You can manually add a channel to the Preview by pressing its MUTE button. Its MUTE LED lights, but it's
not actually muted yet. You can even save it to the Mute Group by pressing STORE and then pressing the
number of the Mute Group you're previewing."
4. On page 47:
Previewing
In the section
Preview mode and save it to memory. The last paragraph in step 3 should read:
"You can manually add a channel to the Preview by pressing its MUTE button. Its MUTE LED lights steadily,
though it's not actually muted yet. You can even save it to the Snapshot by pressing STORE twice."
Step 4 should read:
"Once you've decided on a Snapshot or modified Snapshot configuration, press DO IT
Snapshot, plus any manually muted channels will engage. (Note that any channel mutes manually added to
the Snapshot will mute, but their LEDs will not be lit.)"
Add the following to the end of Step 5:
"...Otherwise, press MUTE PREVIEW
number will stop blinking. (The decimal point LED will blink if you have manually added any mutes to the
Snapshot.)"
The note following step 6 should read:
"The Numeric Display
If you want the display to return to the Snapshot number currently engaged, press the CLEAR button."
5. On page 50:
Using the MIDI
In the section
"The standard MIDI implementation table is located on page 53."
System Exclusive Messages
In the section
"Sysex messages do not change the current state of the console, but only transfer data to and from ULTRA
MUTE's memory. When a Sysex Request is made, two horizontal bars appear in the Numeric Display while
data is being transferred (usually only noticeable during longer data transfers). While the console is receiv-
ing a Sysex dump, the Numeric Display flickers. Once the transfer is complete, use MIDI Note Messages or
Program Change Messages to implement new Groups or Snapshots."
memory, the last sentence in the first paragraph should
Groups, no mention is made of the fact that you can change a Mute Group in
Snapshots, no mention is made of the fact that you can change a Snapshot in
again to exit Preview mode. Press CLEAR and the Snapshot
continues to blink and indicates the last number selected while in Preview mode.
Ports, the last sentence in the first paragraph should read:
(Sysex), the note (second paragraph) should read:
and the new