MSI MS-9249 User Manual page 51

your hard disk drive type is not matched or listed, you can use Manual to
define your own drive type manually.
If you select Manual, related information is asked to be entered to the follow-
ing items. Enter the information directly from the keyboard. This information
should be provided in the documentation from your hard disk vendor or the
system manufacturer.
If the controller of HDD interface is SCSI, the selection shall be "None". If
the controller of HDD interface is CD-ROM, the selection shall be "None".
Access Mode
Capacity
Cylinder
Head
Precomp
Landing Zone
Sector
Halt On
The setting determines whether the system will stop if an error is detected at
boot. Available options are:
All Errors
Disabled
All, But Keyboard
All, But Diskette
All, But Disk/Key
Base/Extended/Total Memory
The three items show the memory status of the system. (read only)
The settings are CHS, LBA, Large, Auto.
The formatted size of the storage device.
Number of cylinders.
Number of heads.
Write precompensation.
Cylinder location of the landing zone.
Number of sectors.
The system stops when any error is detected.
The system doesn't stop for any detected error.
The system doesn't stop for a keyboard error.
The system doesn't stop for a disk error.
The system doesn't stop for either a disk or a key-
board error.
BIOS Setup
3-7