MSI MS-7346 User Manual page 56

M S-7346 M ainboard
Re-Call VGA BIOS From S3
W hen ACPI Standby State is set to [S3/STR], users can select the options in this
field. Selecting [Yes] allows BIOS to call VGABIOS to initialize the VGA card when
system wakes up (resumes) from S3 sleep state. The system resume time is short-
ened when you disable the function, but system will need an VGA driver to initialize
the VGA card. Therefore, if the VGA driver of the card does not support the initializa-
tion feature, the display may work abnormally or not function after resuming from S3.
Power Button Function
This feature sets the function of the power button. Settings are:
[On/ Off]
[Suspend]
Restore On AC Power Loss
This item specifies whether your system will reboot after a power failure or interrupt
occurs. Settings are:
[Off]
[On]
[Last State]
Wakeup Event Setup
Press <Enter> to enter the sub-menu:
Resume From S3 by USB Device
This setting determines whether the system will be awakened from what power
saving modes when input signal of USB devices are detected.
Resume From S3 By PS/2 Keyboard
This setting determines whether the system will be awakened from what power
saving modes when input signal of the PS/2 keyboard is detected.
Resume From S3 By PS/2 M ouse
This setting determines whether the system will be awakened from what power
saving modes when input signal of the PS/2 mouse is detected.
Resume by PCI Device (PME#)
W hen set to [Enabled], the feature allows your system to be awakened from the
power saving modes through any event on PME (Power Management Event).
Resume by PCI-E Device
W hen set to [Enabled], the feature allows your system to be awakened from the
power saving modes through any event on PCIE device.
3-14
The power button functions as normal power off button.
W hen you press the power button, the computer enters the
suspend/sleep mode, but if the button is pressed for more
than four seconds, the computer is turned off.
Always leaves the computer in the power off state.
Always leaves the computer in the power on state.
Restores the system to the status before power failure
or interrupt occurred.