MSI MS-7160 User Manual page 44

If you intend to use the SLI interface for better graphics performance, please
refer to the following instructions.
1. Pull the clasps on the sides of the NV SLI connector to loosen the SLI switch
card (refer to fig.2).
Pull the clasp.
MSI Reminds You...
Make sure that you power off the system before removing the SLI
switch card.
2. Remove the SLI switch card. Flip it over to the other side (SLI mode side) and
insert it slantwise (at 40-degree angle) into the NV SLI connector (fig.3).
3. Press down the SLI switch card untill the clsaps on the sides snap the card
into place (fig.4). Before installing or removing an NV SLI module, make sure
that you unplug the power supply first.
Pres s down the
c a r d u n t i l l t h e
clasps snap it into
place.
Fig.1
Fig.2
Fig.3
Fig.4
Hardware Setup
non-SLI mode
Pull the clasp.
SLI mode
2-27