Presetting Stations; Timer; Setting The Sleep Timer - Aiwa AV-S17 Operating Instructions Manual

PRESETTING STATIONS

The unit can store a total of 32 preset stations. When a station is
stored, a preset number is assigned to the station. Use the preset
number to tune in to a preset station directly.
1 Turn the FUNCTION to select the TUNER function,
and press the BAND button repeatedly to select
the desired band. Then press the N or M
button to select a station.
2 Press the ENTER button to store the station.
A preset number assigned to the station, beginning from 1 in
consecutive order for each band, appears in the display for
two seconds.
3 Repeat steps 1 and 2.
No more stations will be stored and "FULL" appears if a total
of 32 stations have already been stored for all the bands.
NOTE
When the AM tuning interval is changed, all preset stations are
cleared. The preset stations have to be set again.
PRESET NUMBER TUNING
1 Turn the FUNCTION to select the TUNER function,
and press the BAND button repeatedly to select
a band.
2 Turn the MULTI JOG to select a preset number.
When operating with the remote control
Press the TUNER/BAND button while pressing the SHIFT button
to select a band, then press the numbered buttons to select a
preset number.
Example:
To select preset number 25, press 2 and 5.
To select preset number 7 press 0 and 7.
To clear a preset station
Select the preset number of the station to be cleared. Then, press
the ENTER button, and press it again within four seconds.
The preset numbers of all other stations in the band with higher
numbers are decreased by one.

TIMER

SETTING THE SLEEP TIMER

The receiver can be automatically turned off at a specified time.
Press the SLEEP button while pressing the SHIFT button
on the remote control.
The unit will be turned off after about 60 minutes.
To specify the time until the power is turned off
Within 4 seconds after the above, press the TUNING DOWN or
UP button repeatedly.
You can change the time between 5 and 240 minutes in 5-minute
steps.
To check the time remaining until the power is turned off
Press the SLEEP button once while pressing the SHIFT button.
The remaining time is displayed for four seconds.
To cancel the sleep timer
Press the SLEEP button twice while pressing the SHIFT button
so that "SLEEPoFF" appears on the display.
Specified time
ENGLISH
En En En En En
E E E E E
(Españo (Españo
(Españo (Españo (Españo
F F F F F
(França (França
(França (França (França
12