Lorex QLR-0440 Series Instruction Manual page 10

Connect the PC Power Supply cable to the Power Supply connector for the VISTAPRO Main
5)
Board. (This is only required if powering cameras directly from the outputs on the back of
the card or if using the ACC-1200 accessory module.)
6)
Connect the other side of PC Power Pin connection cable (red cable), from the I/O Alarm board, to
the Power Pin on the PC main-board. (Device for remote PC Power On function: QDR-TELS
accessory module)
7)
Connect the other side of PC Power Pin connection cable (red cable) with Power Switch
connection cable on the front of PC case
DVR PC Power Pin Cable
- 10 -
Power Supply Cable of PC
VISTAPRO 4 Power Supply
Cable
PC Power Pin
Power switch cable
connector from front of PC