Konica Minolta Crown II Software Manual page 10

IDLE
1
Enable the TCP/IP protocol.
Crown II printers are shipped with the TCP/IP protocol
enabled. You should, however, verify this.
2
Set the Internet address.
This setting must contain a unique IP address. All Crown II
printers are shipped with a preset
IP address. In most cases you may want to modify this
address, so it doesn't conflict with any other IP address
present in your network or in networks attached.
Your network system administrator should assign the
IP address.
You need the printer's IP address when setting up the Crown
port as described in "Adding a Crown Port" on page 6.
3
Set the subnet mask address.
The subnet mask allows you to limit access to your printer
(for example, departmental divisions). The table below shows
some examples.
Subnet Mask
000.000.000.000
255.255.255.xxx
4
Set the router/gateway address.
If you have a router/gateway in your network and you allow users outside your network environ-
ment to print on your Crown II printer, you may need to enter the router/gateway's IP address
here. The default setting (000.000.000.000) is recommended because it allows for autosensing of
the router/gateway and responds to any router communication received.
5
Set additional Crown II printer parameters.
Although the parameters mentioned above are sufficient for normal operation, you might want to
change other settings in the TCP/IP menu to accommodate your local requirements. When you
are finished making changes, reboot your Crown II printer.
After all printer settings are performed, you must reboot your printer to make sure the changes
take effect.
4
Security Emulations
Administration
Communications
Control Panel
Special Pages
User Access
No limitations (default)
Only users (PCs) having an IP address of 255.255.255.xxx
have access to the printer (the last triplet of the address xxx,
doesn't affect access and can be any value).
Mode
Timeouts Emulation
Serial Min K Spool
CrownNet
Parallel
PS Protocol
NIC
Def Job Prio
Protocol
Internet Address
Subnet Mask
Default Router
Remove Passwords
Remove Hosts
Secure Files
Accnting/revchan
Accnting Timeout
Port Assignment
LPD Banner
Bootp Enable
RARP Enable
SNMP NMS[1...5]
Common
EtherTalk
TCP/IP
NetWare
LAN Manager
TCP/IP
Enable, Disable
xxx.xxx.xxx.xxx
000.000.000.000
000.000.000.000
Yes, No
Yes, No
Yes, No
Enable, Disable
5-600 (sec.)
1-9999
Enable, Disable
Enable, Disable
Enable, Disable
Internet Address,
Community Name,
Access
TCP/IP Connection