Table of Contents
Advertisement
SYSTEM CONNECTIONS
Connecting To A Dolby Digital Decoder
or An Amplifier With Built-in DTS
These instructions enable you to connect your unit to a Dolby Digital decoder or an amplifier with built-in DTS.
To DIGITAL AUDIO
input
Make connections.
Connect the unit and a Dolby Digital decoder or an
amplifier with built-in DTS using either an optional
optical cable or an optional coaxial cable.
NOTES:
For Dolby Digital sound, set "DIGITAL AUDIO OUT" to
"DOLBY DIGITAL/PCM". (
For DTS sound, set "DIGITAL AUDIO OUT" to "STREAM/
PCM". (
pg. 97)
Dolby Digital
decoder or
amplifier with
built-in DTS
Coaxial cable
(not supplied)
Optical cable
(not supplied)
pg. 97)
DIGITAL OUT
Back of unit
IN
Y
VIDEO
S-VIDEO
P
B
LEFT
OUT
P
AUDIO
R
RIGHT
COMPONENT
ANTENNA
OUTPUT
CAUTIONS:
This unit has a dynamic range of more than 110 dB with
regards to its Hi-Fi audio capability. It is recommended that
you check the maximum level if you are going to listen to the
Hi-Fi audio signals through a stereo amplifier. A sudden surge
in the input level to the speakers may damage them.
Some speakers and televisions are specially shielded to
prevent television interference. If both are of the non-shielded
type, do not place the speakers adjacent to the TV set as this
can adversely affect the playback picture.
DIGITAL OUT
(COAXIAL)
(OPTICAL)
L-1
L-2
S-VIDEO
VIDEO
LEFT
L-1
PCM STREAM
AV COMPU LINK
AUDIO
DIGITAL OUT
L-2
RIGHT
CABLE BOX
OPTICAL
COAXIAL
INPUT
Note for connection:
Remove the protection cap
from the optical cable.
95
EN
1
Advertisement
Table of Contents
