Table of Contents
Advertisement
32
EN
DBS Receiver
Control Setting
Place the DBS (Direct Broadcast Satellite) receiver on top
of the unit. Attach the unit's Controller to the top of the
unit with the Controller's transmitter pointed towards the
DBS receiver's remote sensor.
ATTENTION:
The Controller can also control a cable box. If both a DBS
receiver and a cable box are used, position the Controller so its
signal reaches the remote sensors of both the DBS receiver and
cable box.
Your unit
DBS receiver
Controller
Your unit
DBS receiver
Controller
(suggested locations)
To RF
To Audio/
output
video
output
Transmitter
or
To AUDIO/
To
VIDEO
ANTENNA
INPUT
IN
CABLE
BOX
INITIAL SETTINGS (cont.)
The following procedure is required if you receive
satellite channels through a DBS (Direct Broadcast
Satellite) receiver. The Controller allows the unit to
automatically switch the DBS receiver's channel during
timer recording.
NOTES:
The unit can automatically change the DBS receiver channels
using the Controller when the unit has been programed using
"Manual Timer Programing" (
Because satellite programing does not use PlusCode, the
Controller cannot change the DBS receiver channels during
"VCR Plus+
Timer Programing" (
®
If a cable box is also used, it is recommended that you
connect the DBS receiver to your unit's audio/video input
connectors and the cable box to your unit's antenna input
connector.
Installing Controller
A
Install a Controller.
Place a Controller so that the path between its transmitter
and the DBS receiver's remote sensor is unobstructed.
B
Attach the Controller.
Fix securely using the adhesive strip attached on the back
of the Controller.
C
Make connections.
If your DBS receiver does not have audio/video output
connectors
Connect the RF output
connector
the ANTENNA IN connector on the rear of your unit.
If your DBS receiver has audio/video output connectors
Connect an audio/video cable between the AUDIO/
VIDEO INPUT connectors on the rear of the unit and the
audio/video output connectors on the DBS receiver.
NOTE:
When connecting your DBS receiver, refer to its instruction
manual.
D
Connect the Controller to unit.
Connect the Controller to the CABLE BOX connector on
the rear panel.
How to control the DBS receiver
This unit has two separate methods to control your DBS
receiver.
The unit's wireless Remote can control your DBS receiver.
This eliminates the need for a separate DBS receiver's
Remote.
The unit's Controller can also control your DBS receiver.
This allows the unit to change your DBS receiver's channel
number during timer recording.
Each method must be set up separately. To set up the unit's
Remote, refer to page 94. To set up the Controller, go to
page 33.
pg. 64).
pg. 60).
on the DBS receiver to
Advertisement
Table of Contents
