Special Recording; Pre Rec - JVC GY-HM750CHU Instructions Manual

Shooting
Dual Rec (continued)
Note :
● To perform recording in the Dual Rec mode, it is
recommended that you start recording by making use of
two cards with the same capacity and from the formatted
state.
● You can combine the use of the Dual Rec mode with a
special recording mode. While in the Dual Rec mode, you
can also set [Rec Mode] to Normal , Pre Rec , Clip
Continuous , or Variable Frame .
( A Page 58 [Special Recording])
( A Page 76 [Rec Mode])
● When both the slots are loaded with recordable cards, the
Dual Rec (simultaneous recording) operation can be
performed. If a recordable media is only loaded to one of
the slots, you can also start recording with one card.
● In the Dual Rec mode, continuous recording by switching
from one slot to another cannot be performed. Continuous
recording will not be performed if a recordable media is
loaded to a slot after recording to the other slot has
started.
● When recording to one slot is in progress with the
recorder set to the Dual Rec mode, loading a recordable
media to the other slot does not enable the Dual Rec
operation. To perform the Dual Rec operation, stop
recording temporarily (excluding pausing recording in the
Clip Continuous Rec mode), and start again.
● When one of the cards is accidentally removed while the
Dual Rec operation is in progress, recording to the card in
the other slot will continue. However, repair of the
accidentally removed card by the recovery function may
fail.
● If an error occurs on one of the cards in the two slots
during recording, recording of the erroneous card stops,
while that of the other card continues.
● Operations on clips recorded in the Dual Rec mode, such
as clip deletion in the Media mode or appending of OK
marks, can only be performed on the card in the selected
slot.

Special Recording

Besides the normal recording mode, three special recording
methods are available in this camera recorder. They are Pre
Rec, Clip Continuous Rec, and Variable Frame Rec.
Select the mode from [Rec Mode] in the [Record Set] menu.
* Set using [Main Menu] B [Record Set] B [Rec Mode].
(A Page 76)

Pre Rec

By setting the number of seconds in the [Pre Rec Time], you
can start recording video and audio before actual recording
starts based on the Pre Rec Time setting.
When starting actual recording while the camera recorder is
in Recording Standby (STBYP) mode, you can start
recording a few seconds earlier based on the [Pre Rec Time]
setting.
Using Pre Rec allows you to record a complete event without
missing the initial scenes even if you start the recording late.
* Pre Rec Time can be set to 5sec , 10sec , or 20sec
in [Main Menu] B [Record Set] B [Pre Rec Time].
(A Page 76)
Completed Clip
(Recorded video and audio)
Recording starts a
number of seconds
earlier based on the
[Pre Rec Time]
setting
Press [REC]
(Recording starts)
1
Set [Rec Mode] to Pre Rec . (A Page 76)
● Set [Main Menu] B [Record Set] B [Rec Mode] to Pre Rec .
● The status display changes from STBY B STBYP .
2
Press the [REC] button to start recording in Pre Rec
mode.
● The status display changes from STBYP B RECP
and the card slot status indicator lights up in red.
● Press the [REC] button again to pause recording. The
display changes from RECP B STBYP and the card
slot status indicator lights up in green.
Note :
● When the interval between start and stop recording is
short, STBYP may not be displayed immediately after
recording is complete.
RECP B STBYP (STBY blinks in red) B STBYP
is displayed.
● When the SDHC card becomes full during recording,
recording stops and STOP is displayed.
Press [REC]
(Recording stops)