Interphase Sonar Engine SE-200 Operation Manual page 31

will appear to be slanted upwards or downwards. After
mounting the transducer and actually using the SE-200
on the water, you may need to readjust the transducer's
mounting for optimum performance.
Bracket Axle Assembly
On some boats it will be neccessary to remove the
Bracket Axle during installation. See the diagram to the
left and instructions below for details on assembling the
axle.
1. Place one stainless steel washer onto the axle
against the hex end.
2. Place one small stainless steel spacer against washer.
3. Slide two urethane spacers over the small steel spacer.
4. With the transducer bracket in place, align the long
stainless steel spacer with the mounting holes of the
mounting bracket and slide the axle in place.through the
spacer.
5. Place one small stainless steel spacer against the
transducer bracket.
6. Slide two urethane spacers over the small steel spacer.
7. Place one stainless steel washer onto the axel against
the urethane spacer.
8. Place the nylok nut onto the threaded end of the axel
and tighten to 50 inch pounds. If you do not have a
torque wrench, tighten until the nut will not turn easily.
The stainless steel spacers should prevent over-
tightening.
Bracket
Axle
Nylok
Nut
5
8
7
6
Kick-up Bracket Replacement Parts
If during installation parts are somehow lost are
damaged, they can be replaced as follows:
Part# 17-0088-008 - Spray Shield Kit - Includes:
Spray Shield, four Mounting Bolts and Nuts,
Rubber Grommet and four Large Mounting
Screws.
Part# 17-0089-008 - Transom Transducer
Hardware Kit - Includes: Complete Bracket Axle
Assembly and four Large Mounting Screws.
Part# 17-0056-008 - Kick-Up Bracket Assembly -
Includes: Complete Bracket Axle Assembly, four
Large Mounting Screws and the Stainless Steel
Mounting Bracket.
31
2
1
3
4