Intermec EasyCoder PF2i Install Manual page 8

Chapter 1 — Physical Installation
• Connect the EasyLAN board to the PCI connector (J84) on the CPU
board so the hole in the interface board becomes aligned with the
spacer.
• Secure the EasyLAN board with the #T20 Torx screw you previously
removed.
• From the inside of the electronics compartment, press the metal
socket of the network extension cable into the square hole in the rear
plate (where you removed the LAN plug) until it is held by its snap-
lock.
• Route the extension cable over the SIMMs on the CPU board and
connect it to the RJ-45 socket on the EasyLAN interface board (J2).
• From the outside, insert the thin end of the light guide through the
small hole next to the RJ-45 socket on the rear plate. Press the clear
plastic "lamp" in place. Connect the other end to the black plastic
socket (D1) on the EasyLAN interface board.
• Pull the cable tie through the hole in the upper edge of the CPU
board between the SIMMs and the RTC socket. Secure both the
extension cable and the light guide with the cable tie.
• Fit the serial number label to the printer's rear plate below the RJ-45
socket and to the right of the memory card slot.
• Put back the front/left-hand cover. Route the cable from the display
unit above the ribbon motor. Connect the cable to connector J50 at
the upper right corner of the CPU board.
• Connect the power cord and switch on the power.
• Enter the Setup Mode and print the test label "Hardware Info" to see
if the printer detects the EasyLAN interface board. For information
on how to enter the Setup Mode, refer to the User's Guide for the
printer in question.
• Connect the network cable to the RJ-45 socket on the printer's rear
plate.
• Set up the network parameters. See Chapter 2.
4 Intermec EasyLAN Interface Kit Installation Instructions