Hitachi Director's P50X901 Operating Manual page 13

Front Panel Controls
UPGRADE CARD
This card slot is for future software upgrades.
Hitachi will notify you if a software upgrade is
required for your TV. In order to receive written
notification, please complete and return your
warranty card.
SD CARD PHOTO INPUT
To view digital still pictures, please insert a SD
card into the card slot with pictures taken on a
Digital Camera, to view them on the TV screen.
POWER light indicator
To turn the TV ON, press the main power
switch located on the lower right side of the
TV. A red stand-by indicator lamp located on
the lower right corner of the front bezel will
illuminate. The Plasma TV is now ready for
remote ON/OFF operation.
Indicating Lamp Power Status
OFF.
Off *
OFF.
Lights
Red (Stand-by)
Lights
Blue
Lights Off
Orange (Power Saving)
Blinking
On
Blue
* The Main Power switch applies only for P50X901 model ; so for the P60X901 the
condition for the Indicating Lamp when is OFF , it means that the AC power cord
is unplugged.
REMOTE CONTROL sensor
Point your remote at this area when selecting
channels, adjusting volume, etc.
LEARNING AV NET sensor
Point your equipment's remote control at this area
while using the AV NET Learning Wizard.
INPUT-FRONT JACKS
INPUT-FRONT provide composite Video jacks for
connecting equipment with this capability,
such as a DVD player or Camcorders.
NOTES: 1. Your HITACHI Plasma TV will appear to be turned OFF (lights orange) if there is no video input
when INPUT : 1, 2, 3, Front or HDMI : 1, 2, Front is selected. Check the Power Light to make sure
the TV is turned off or in Stand-by mode (lights red) when not in use.
2. Remote Control cannot turn ON/OFF the "MAIN POWER" of the TV.
Operating
When the main power switch is set to Off.
When the main power switch on the TV is ON.
On
TV POWER is ON ; picture is shown.
TV POWER is ON with no signal input
except antenna (no sync. signal).
When TV receives the IR signal from R/C.
PHOTO INPUT
PUSH EJECT
Indicating Lamp
R/C, AV Net Sensor
13