Grizzly G0623X Owner's Manual page 32

36. Use a straightedge to make sure the riving
knife and scoring blade are aligned with the
main blade. The alignment should be with the
blade bodies, not the carbide teeth.
—The riving knife position can be changed by
adjusting the setscrews at the riving knife
mounting block. Refer to Page 38 for more
details.
—The scoring blade alignment can be
changed by adjusting the set screws acces-
sible through the table top (see Figure 41
or refer to Page 39).
Scoring Blade Elevation
Scoring Controls Lock
Figure 41. Access holes for scoring blade
adjustment controls.
-30-
37. Install the blade guard on the riving knife, as
38. Assemble miter gauge and push handle as
Scoring Blade
Alignment
shown in Figure 42, with the M8-1.25 x 40
button head cap screw shipped in the blade
guard. (The blade guard/dust hood MUST be
installed.)
Figure 42. Blade guard installed.
shown in Figure 43.
Push Handle
Figure 43. Push handle and miter gauge
installed.
G0623X/G0623X3 10" Sliding Table Saw
Miter Gauge