Grizzly G0623X Owner's Manual page 30

24. Remove the shipping brace from the sliding
table (Figure 31), then install the sliding table
end cover over the fixed part of the sliding
table end, as shown in Figure 32, using the
premounted hardware.
Figure 31. Sliding table shipping brace.
25. Attach the sliding table handle, as shown in
Figure 33, with two button head screws and
flat washers, using the premounted hard-
ware.
-28-
26. Thread two M5-.8 x 12 cap screws with 5mm
lock washers through the switch bracket and
into the sliding table base, and tighten the
cap screws (see Figure 34).
G0623X/G0623X3 10" Sliding Table Saw