Grizzly G0623X Owner's Manual page 31

29. Adjust the feet downward so they press
against the floor, then tighten the hex nuts up
against the support leg so the feet are locked
in place.
30. Open the cabinet door and remove the motor
shipping brace shown in Figure 36.
Figure 36. Motor shipping brace.
31. Tilt the blade assembly to 0˚, then slide the
sliding table forward all the way until you can
open the lower blade guard cover and access
the blade arbors.
32. Insert the arbor lock tool into the hole shown in
Figure 37, rotate the arbor until the arbor lock
tool seats, then install the main blade, using
the included arbor wrench. There MUST be
an arbor flange on both sides of the blade.
Figure 37. Installing main blade.
G0623X/G0623X3 10" Sliding Table Saw
Arbor
Lock
Tool
33. Insert the arbor lock tool into the hole shown
in Figure 38, rotate the arbor until the arbor
lock tool seats, then install the scoring blade,
using the arbor wrench. There MUST be an
arbor flange on both sides of the blade.
Arbor
Lock
Tool
Figure 38. Installing scoring blade.
34. Install the riving knife as shown in Figure 39,
but do not tighten the mounting bolt yet.
Figure 39. Installing riving knife.
35. Adjust the riving knife approximately
from the main blade, using a
wrench as a guide (Figure 40).
Figure 40. Adjusting the riving knife spacing.
⁄ " away
1
8
⁄ " or 3mm hex
1
8
-29-