Grizzly G0623X Owner's Manual page 29

18. Insert the two crosscut brace knobs with
8mm flat washers through the crosscut table,
then thread the square nuts onto the ends of
the knob threads (Figure 27, A). Slide the T-
slot in the support bar over both T-nuts, and
tighten the knobs (Figure 27, B).
�������
����������
���
�
�����������
���
����
������������
Figure 27. Installing support bar on crosscut
table.
19. Slide the pivot stud assembly and the M8-
1.25 x 60 T-bolt into the crosscut fence T-slot,
as shown in Figure 28.
Pivot Stud
Assembly
T-Bolt M8-1.25 x 60
Figure 28. Pivot stud and T-bolt installed in
crosscut fence.
20. Align the T-bolt and pivot stud with the cross-
cut table insertion points (Figure 28), and
install the fence on the table.
21. Thread the M8-1.25 knob with an 8mm flat
washer onto the bottom of the T-bolt from the
underside of the table.
G0623X/G0623X3 10" Sliding Table Saw
��������
�������
�����
�
������������
�����������
���
����
������������
22. Hold the crosscut fence against the positive
stop bolt, shown in Figure 29, then tighten
the knob underneath the crosscut table to
lock the crosscut fence in position.
Note: This positive stop bolt can be fine-
tuned later to ensure that the crosscut fence
is square to the blade.
Figure 29. Positive stop bolt against the crosscut
fence.
23. Install the flip stops in the T-slot on the cross-
cut fence, as shown in Figure 30, and use
the crosscut fence lock knob to secure the
extendable end of the fence in position.
Flip Stops
Crosscut Fence Lock Knob
Figure 30. Flip stops installed on crosscut fence.
Positive
Stop Bolt
M8-1.25 x 25
-27-