Table of Contents
Advertisement
Shaper Conversion
Components and Hardware Needed:
Shaper Cutter Spindle ....................................... 1
Original Bolts Removed From Table
Hex Bolt M12-1.75 x 20 ............................. 2
Hex Bolt M12-1.75 x 30 ............................. 5
Tools Needed:
Flat Wrench 26mm ............................................ 1
Wrench 14mm ................................................... 1
Wrench/Socket 17mm ....................................... 1
Wrench 8mm ..................................................... 1
Wrench 30mm ................................................... 1
Use these procedures to convert the Model
G0510Z from a router table to a shaper.
The Model G0510Z can still use shaper cutters
without removing the table spacers, but you may
not be able to use the full profile of all cutters with
the table in this position.
To convert Model G0510Z from use as a router
table to a shaper:
1.
DISCONNECT SHAPER FROM POWER
SOURCE!
2.
Remove any router bits that are installed in
the collet.
3.
Remove table and table spacers from the
shaper by undoing the seven bolts that
secure the table in place.
-32-
4.
Replace the table with the original mounting
bolts you removed when you converted the
shaper for use as a router table.
Qty
5.
Insert the spindle/drawbar assembly into the
spindle cartridge.
6.
Thread the drawbar nut onto the bottom of
the drawbar with the taper side up.
Qty
7.
Tighten the taper nut by holding another
wrench on the spindle flats, as shown in
Figure 41.
Figure 41. Tightening taper nut to install shaper
cutter spindle (pulley guard removed for clarity).
G0510Z 3⁄4 HP Shaper
Advertisement
Table of Contents
