Section 2: Circuit Requirements; 110V Operation - Grizzly G0510Z Instruction Manual

SECTION 2: CIRCUIT REQUIREMENTS

110V Operation

Serious personal injury could occur if you
connect the machine to the power source
before you have completed the set up pro-
cess. DO NOT connect the machine to the
power source until instructed to do so.
Amperage Draw
The Model G0510Z motor will draw 10 amps at
full load.
Circuit Requirements
We recommend using a dedicated circuit for this
machine. You MUST connect your machine to a
grounded circuit that is rated for the amperage
given below. Never replace a circuit breaker on
an existing circuit with one of higher amper-
age without consulting a qualified electrician to
ensure compliance with wiring codes. If you are
unsure about the wiring codes in your area or
you plan to connect your machine to a shared
circuit, consult a qualified electrician.
110V Circuit ............................................. 15 Amp
Plug Type
The Model G0510Z is supplied with a 5-15 plug,
similar to Figure 3.
Figure 3. Typical type 5-15 plug and receptacle.
-8-
Electrocution or fire could
result if this machine is
not grounded correctly or
if your electrical configu-
ration does not comply
with local and state codes.
Ensure
checking with a qualified
electrician!
This machine must have a ground prong in
the plug to help ensure that it is grounded.
DO NOT remove ground prong from plug
to fit into a two-pronged outlet! If the plug
will not fit the outlet, have the proper outlet
installed by a qualified electrician.
Extension Cords
We do not recommend the use of extension
cords. If you find it absolutely necessary:
• Use at least a 14 gauge cord that does not
exceed 50 feet in length!
• The extension cord must also contain a
ground wire and plug pin.
• A qualified electrician MUST size cords over
50 feet long to prevent motor damage.
NOTICE
The Model G0510Z cannot be rewired for
220V operation! Attempting this will void
the warranty and ruin the machine.
compliance by
G0510Z 3⁄4 HP Shaper