Gigabyte GA-VM800PMC User Manual page 65

A. Create Array:
In Main Menu, select Create Array and press ENTER, a screen similar to Figure 5 below will appear.
Auto Setup For Performance
Array Mode RAID 0 (Striping)
Select Disk Drives
Block Size 64K
Start Create Process
Channel Drive Name
Serial_Ch0 Master ST3120026AS
Serial_Ch1 Master ST3120026AS
The first step to create a RAID array is to set the RAID mode. Select Array Mode and press ENTER.
And the RAID mode selection menu will appear (Figure 6). The supported RAID modes include RAID
0 for performance, RAID 1 for data protection, and RAID SPAN for capacity. Use the UP or
DOWN ARROW key to select a RAID mode.
Auto Setup For Data Security
RAID 0 for performance
Array Mode RAID 0 (Striping)
RAID 1 for data protection
Select Disk Drives
RAID SPAN for capacity
Block Size 64K
Start Create Process
Channel Drive Name
Serial_Ch0 Master ST3120026AS
Serial_Ch1 Master ST3120026AS
VIA Tech. VT8237 SATA RAID BIOS Ver 4.97
Create a RAID array with
the hard disks attached to
VIA RAID controller
F1
Enter : Confirm the selection
ESC
Array Name
Figure 5
VIA Tech. VT8237 SATA RAID BIOS Ver 4.97
Create a RAID array with
the hard disks attached to
VIA RAID controller
F1
Enter : Confirm the selection
ESC
Array Name
Figure 6
- 65 -
: View Array/disk Status
, : Move to next item
: Exit
Mode Size(GB)
SATA 111.79
SATA 111.79
: View Array/disk Status
, : Move to next item
: Exit
Mode Size(GB)
SATA 111.79
SATA 111.79
Status
Hdd
Hdd
Status
Hdd
Hdd
Appendix